Installation

Questions about installing and configuring a Fluksometer.

DIN Kwh counter

by kevinevo7 on

Hi,

I've got 2 solar inverter and also 2 DIN Kwh counters.
Can I connect both counters to the Fluko?
Can it be configured that the 2 values sum up?

Regards, Kevin.

Smart sensors not properly reporting to dash

by Jaap on

My smart meter seems to be reporting fine to the Flukso through the P1 port

The data shows on the Flukso as below but the dash initially didn't show the smart sensors.

After half an hour the main electricity started reporting and after an hour or so a few gas resukts came through.

  1. !
  2. /ISk5\2ME382-1003
  3.  
  4. 0-0:96.1.1(xxxxxxxxxxxxxxxxxxxxxxxxxx)
  5. 1-0:1.8.1(00001.492*kWh)
  6. 1-0:1.8.2(00000.000*kWh)
  7. 1-0:2.8.1(00000.000*kWh)
  8. 1-0:2.8.2(00000.000*kWh)
  9. 0-0:96.14.0(0001)
  10. 1-0:1.7.0(0000.56*kW)
  11. 1-0:2.7.0(0000.00*kW)
  12. 0-0:17.0.0(0999.00*kW)
  13. 0-0:96.3.10(1)
  14. 0-0:96.13.1()
  15. 0-0:96.13.0()
  16. 0-1:24.1.0(3)
  17. 0-1:96.1.0(xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx)
  18. 0-1:24.3.0(xxxxxxxx0000)(00)(60)(1)(0-1:24.2.1)(m3)
  19. (00000.310)
  20. 0-1:24.4.0(1)
  21. !

The syslog has produced lots of these

  1. Dec  x xx:xx:xx flukso-xxxxx daemon.warn avahi-daemon[644]: server.c: Packet too short or invalid while reading probe record. (Maybe a UTF-8 problem?)

Fluksometer for 1 phase PV and 3 phase consumption

by ErikKlaas on

Hi there,

I am trying to figure out what I need to measure my 3 phase consumption as well as my PV production.
Would one Fluksometer be enough to do that? Which should I order

Erik

Pre-purchase questions

by AceNZ on

What happens if the rated power for the current sensor clamps is briefly exceeded? Will it damage anything, or will they just not work, or produce invalid results? I have 60A service, but it very rarely gets above 40A, and if/when it does, it's only briefly, and I don't care about tracking those numbers.

Does the Fluksometer v2 come with an Australia/New Zealand 240V adapter?

Is there normally much of a delay between the time I place an order, and when the units ship? Or do you carry them in stock?

Which carrier do you use for shipments to New Zealand?

Support for Itron ACE3000 export meter?

by AceNZ on

My power company has installed an Itron ACE3000 type 260 export meter.

The meter seems to have a (dark) LED on the front, labeled something like "1000 impulses per kWh."

Is it possible to interface this type of meter to a Fluxso? If so, any details would be appreciated.