Hello,
i have a big problem with a flukso electrical sensor. In the minute display i get every time the error: "Error - The call for sensor L3 experienced a timeout. You are probably not in the same local network as the FLM."
Is the sensor L3 broken?
mfg
Is it possible to use 1 clamp instead of 3 when you know that the load is the same on each phase?
per example a motor!
/Peter
Hi,
This is my first post in the forum. I've been looking for a solution but didn't found anything so I've opened a new thread. There is my problem:
I'm thinking about recording temperature with one of the flukso analog inputs, so I need to know input requirements in order to find a sensor that suits on the flukso. Does someone know the specs of the analog inputs (Input type, voltage or current range...), please?
Thank you!
So folks I have a Flukso meter connected to two DIN-rail meters with pulse output in the meter box. One meter monitors consumption and the other monitors the power coming from the solar inverter.
Data is coming out fine, except that my consumption is closely following my solar generation.
See here: http://pvoutput.org/intraday.jsp?id=13740&sid=12392
It seems that generation is getting seen as consumption. When generation exceeds consumption, the consumption meter reads "reverse current" on its external panel but I'm assuming it's still generating pulses.
Right now, the solar output feeds into the output side of the consumption meter. Should I feed the solar output to the input side of the consumption meter? Or is there a programmatic change I can make to have the data calculated correctly?
I'm sure the answer is simple...but I'm very confused at the moment.
Hi.
I have a couple of questions hoping somebody can help:
1. I have 3 Phase electricity coming into my home but my Inverter is only single phase.
Do I need to purchase 2 Fluksometers and 4 clamps (1 for each phase - clamped to my consumption side and 1 clamp for the solar leg) ?
2. Can I send the data up to pvoutput and graph solar and consumption ?
Thanks.
