Is it possible to use the gas (and water) probe with a raspberry pi ? Can you connect this directly to the GPIO of a pi ?

Thanks !

I have just sold my previous FLM. The purchaser has come back saying he cannot make an account as this site wont take the serial number . Message is:

Please specify a valid serial number.

View Edit Orders Subscriptions

He has sent an message thru the 'contact' page but no one has answered?

Any clues what I should tell him?

From the manual:

Select the number of phases that apply for your current clamp setup. When
selecting 3 phases, the three current clamp ports will be grouped and presented
as a single sensor #1. Sensors #2 and #3 will be disabled automatically after
saving.

What does "Sensors #2 and #3 will be disabled automatically" mean? After saving I can still enable/disable them. It seems that only sensor #1 is measured with 3 phases selected.
I'm using Google Chrome.

Regards, Hans

Hello,

Is it possible (and do I have most features) to install Flukso only in the local network ? I don't want to send all my information about my elec/gas/water to a public space.

thanks a lot !

I've just set up an FLM02B with three pulse sensors, "Fridge", "Hot Water", and "Main". Fridge is a subset of Main, the latter is for the whole house while Fridge and Hot Water should be a fraction of the reading from Main.

However on the dash I only get a graph for "Fridge", which happens to be the first sensor listed on the Settings | Sensors list. Is there something extra I need to do to enable readings for the other sensors?