The power supply feeding a v2 blew up last night causing our safety switch to trip, possibly saving the house from burning down.

See attached image to see the aftermath.

After some years my Flukso started to report incorrectly (time sync lost) and now won't respond to the console. First it showed error messages and now it just times out.

Device is Fluksometer v2b. What are my options here?? Can it be reset somehow or must it be replaced.

Is there anything specific that I need to do to activate the water pulse sensor?
Its not recording anything on my dashboard and my pulse meter works just fine...

I keep getting:

×
Error - The call for sensor Water Main experienced a timeout. You are probably not in the same local network as the FLM.

Please help.

Thanks.

In manual of #E version it states "P1 poort" for smart meter not functional yet , is this already resolved?

How many pulse ports ar posible with 3e?

Ports 1, 2, 3 clamp ports but also configuarable to pulsseport?
Ports 4,5,6 pulse port
Port 7 to use for dutch smaart meter?
So 3E can manage one extra source in comparison with 2B?

The new featueres for kubes, when will cube be sold in shop or is it a do your self project?

Flukso FLM02 250 with following 3 phase readings (1-2-3) lost readings of water meter some weeks ago.
Imbedded battery was dead after 4 years of service (as indicated by vendor).
I ordered a new one in the UK with a battery life (guaranteed!) of 7 years. No readings.
Checked the 25 meter connection (pair) cable ==> OK (measuring 9V left side = 9V right side.
Checked + - <==> - + (yellow/black, CH1P/GRND) <==> black/yellow (GRND/YELLOW) ==> no readings.
I mean I inverted the pair to check if + - is connected on the right sub port.
I used yellow and black (ground). Is this correct?
Checked log and tx buffer ==> xxxxxxx3925 (phase 1) logged and OK (2 and 3 are part of one 3 phase group
Checked log and tx buffer ==> xxxxxxx3aa6 (port 4) NOT logged and NOK while water is flowing and pair cable
connected.
Checked log and tx buffer ==> xxxxxxx3eed (port 5) NOT logged and NOK while water is flowing and pair cable
connected
I have only one water meter connected to port 5 + -.; 4 + - is a "spare" port.
I saved the sensors several times with enable disable.

Can't see any issue on the log/mptx.
I browsed the forum several times. Can't find anything.
Did I miss a setting? What should I do with the available 32 hex sensor ids (xxxxxxxx3ee8)? disable or delete them?
Flukso FLM is 8 years old, new Elster PR6 is a few days.
Any help appreciated

Marc Verbeke