Do pulse meters pulse on import and export if in a net situation?

Can they be configured to pulse in import only?

Whats a decent single phase pulse meter?

Just installed a new FLM03E to replace a V2 (for a while they will run in parallel to monitor the differences)

It's connected to the LAN over wifi.
I gave it a DHCP reserved address on the router, I can ping it but not browse to its local webpages.

Now I remember I had to change config manually to allow this on V2, is that still the case with V3?
Same with ssh access.

Just asking before I head over to the installation with a laptop ;)

Hi,
I moved my fluksometer v3 to my new apartment and can't get the readings rights. Previously everything looked fine, now the flmlocal interface shows just 0.7V on each phase and the dash graph shows 0W. Is there something wrong with the configuration or the wiring?

Images of the flmlocal gauge visualizations of no load and load on each phase:
https://imgur.com/a/Djq6ZCk

My configuration:
Electrical system: 3 phases with N
Math: port1 + port 2 + port 3
Ports 1-3: representing each phase

I pressed the upgrade button under devices to upgrade my Flukso FL03001461 from Ver 247 to 250 but it doesn't want to upgrade itself.
Here is the data after pressing upgrade:

The FLM with serial FL03001461 will be upgraded to firmware version 250 at the next FLM heartbeat.

Serial Version Resets Last heartbeat Uptime Operations
FL03001461 250** 57 07 Sep 2018 14:01:07 0d 19h

Here are the readings an hour & 10 min later after the next heartbeat:
Serial Version Resets Last heartbeat Uptime Operations
FL03001461 247 57 07 Sep 2018 15:01:15 0d 20h remove upgrade

I did it number of times over the weekend. Still the same ver 247 without the upgrade.
Any ideas?

is there a changelog from V247

is it worth updating?
i have read it affects FMlocal is there anything else?