Site down Plus Temp question raised by member
by
on12 hours today.Daytime in Oz :(
12 hours today.Daytime in Oz :(
Hi all,
I suddenly ran into issues with my Flukso (FLM02B, firmware version 250).
As written in another post (https://www.flukso.net/content/flm02b-version-250-inconsistent-number-se...) the dash only shows 2 active sensors.
In the flukso.net -> settings page, there are 12 (!). Now I noticed the following error on my flukso device:
sensor board hardware compatibility check failed Internal error.
Please report this error message to Flukso.
Any pointers how to fix this issue?
Eric
Since 14:49 yesterday 21 May there is no access to Flukso server and as a result the usage data is not recorded. You can see it checking any member in the Flukso group on PVoutput.
Please rectify this problem asap.
Tx
This might sound a little bit weird :), but I came across a picture of the same water meter I have with the Smappee optical sensor attached to it (of course attached to the Smappee box).
Does anyone know if I could buy that sensor, cut off the connector, strip and attach the wires to the Flukso?
To be honest, I have all components to create an optical sensor myself, but I really don't know how to attach it to the meter. And seeing that picture, I got triggered, even though it is not that cheap...
cant edit my sensors for some reason.
they are all still working but got this error
https://www.dropbox.com/s/rgox12gi38mdb7j/sensorissue.PNG?dl=0
If i done a factory reset would i have to setup my sensors again?
can i copy the sensor setups from somewhere and place them back in after a reset