Concerning the Fluksometer v2b (FLM02B) with the Gas probe (FLS02-F1):

I cannot get a single reading for GAS on the Actaris G4 RF1.
Can anyone tell how /where to put the sensor on this type of meter?
On the photo is how I tried it. Also with the sensor turned (text on the bottom) this is not getting ANY readings. The sensor is connected to port#4 and configured as Gas with constant 10. So far not a single reading is logged. Directly reading the sensor gives empty results: []
Anyone who can help me with this?

Beste,

mijn watermeter toont in de nachturen "0,015 liter"
is dat een meetfout, of heb ik echt een lek?

want als ik bij de voorbeelddash kijk en 's nachts bekijk zit daar ook aan 0,03 waarden?

kan ik voorbeeld ergens de 'ticks' zien zonder op toestel zelf in te loggen?
heb nl klacht van mijn buur dat er bij hem vochtige muur is door een lek bij mij, en dus belangrijk ( en dringend ) voor mij.

Gr

Bruno

Is there a limit to how much power the S0 can register on the fluksometer?
I seem to have a problem occuring at approx. 72kWh.
I´v tried 1000,100 and 10 pulses/kWh and corresponding constant on the meter.
I can get a correct reading when in minuteview on the dash but on the hourview there is no curve above 72kWh!

Ryftes

Hi,
Ive purchased the 80w meter from here :

http://www.schnap.com.au/kilowatt-hour-meter/single-phase-electric-kilow...

I was just wondering is there any documentation on how to plug this into the flukso? The electrician is coming over to install the outlet needed and the din but im not sure how he wires it up to the flukso? The wires going into the meter look a lot thicker than what the flukso will accept?

Any help would be great!

Cheers,

Christian.

https://getsatisfaction.com/pvoutput/topics/add_water_gas_sensor_and_tok...

I donated to get the extra fields for gas and water.

See link below for info how to add

Baz