Hello,

i have a Kent v200-like water meter (http://www.kentmeters.co.uk/en/V200_V210.html).
From my understanding of the spec, it has an inductive pulse target. I guess that means the flukso reed-based probe does not work with it?

Does someone know a way to get this to work with flukso?

thank you,

Ph. Duchesne

Hello everybody,

just a short question: We set up the Fluksometer to receive data from a SmartMeter that is attached using an optocoupler.

The SmartMeter, though, speaks SML. Is there any way for the Flukso to deal with SML so far?

Thanks in advance

SolarWasher

Hi,

I just installed the Fluxo and hooked it on the sensor (pulse) on port 4. Although everything seems to be okay I do not have any reading on the Dash and also in the list of Sensor it says: no sensors.

I double checked the configuration and there the sensor 4 is active cand alled Verbruik.

I check the polarity and all is OK.
I open the Fluxo to check whether the daughterboard was connected to the main socket; all fine.
I disconnected the kwh-meter and simulated the pulses but still nothing.
Wifi, heartbeat and globe: all of them led's are on.

Is there any other way to test/fix this?

Regards,

Jorgo

My browser is showing this as I try to show the "minute" om the Flukso webside:

Error - Real-time charting is not available on this Fluksometer. If you have an FLM02, then please upgrade to the latest firmware release on the my account -> devices page.

I am using the ver. 216 firmware.

What to do ?

Hi.

I have an actaris g4 gallus 2000 gas meter:

specs: http://www.minolusa.com/pdf/ACTARIS%20--%20Gallus%202000%20Specs.pdf
installation guide: http://www.follinflo-controls.com/PDFs/diaphragms/Gallus2000_Install_wir...

Do you know if the FLS02-F1 would work with it ?

The page in the shop only says "The probe is compatible with the Elster BK-G4/BK-G6 and the Actaris G4RF1 gas meters."

There is a magnet (I check with a compass), but it does not trigger the Hall effect sensor I tried on it.

More information here about the sensor and what I have done already:
http://openenergymonitor.org/emon/node/1732

I chose a Hall effect sensor instead of a reed switch to avoid having to deal with debouncing. From the price, I guess the FLS02-F1 has debouncing included. Is this correct ?

How is the FLS02-F1 interfaced ? I see only two cables on the picture. Is the ground in the foil ?

Thanks