Then, while accessing it via wired interface to check the log (which showed nothing special except it couldn't resolve network hosts), it suddenly connected again, shows up on the website under devices (heartbeat received) but no data being uploaded.

Any thoughts on how to figure out what's happening?

I saw a lot of people are using PVoutput to upload sensor data. I was trying to do the same but face very strange problem.
Consumption shown on pvoutput is always double consumption shown on flukso graph.
Does anyone has hints on how to fix this ?
thanks a lot

Hallo,

Ik heb 3 clamps 100,50 en 100A op separate kabels geklemd (1-fase) zonder de 'schil' te verwijderen.
Op dit moment ontvang ik de data als volgt (vb 1 sensor)
http://192.168.20.43:8080/sensor/80ef4aa13a52aae5279c36b41e96b4c2?versio...
levert
realtime([[1347701413,0],[1347701414,0],[1347701415,0],[1347701416,0],[1347701417,0],[1347701418,0],[1347701419,0],[1347701420,0],[1347701421,0],[1347701422,0],[1347701423,0],[1347701424,0],[1347701425,0],[1347701426,0],[1347701427,0],[1347701428,0],[1347701429,0],[1347701430,0],[1347701431,0],[1347701432,0],[1347701433,0],[1347701434,0],[1347701435,0],[1347701436,0],[1347701437,0],[1347701438,0],[1347701439,0],[1347701440,0],[1347701441,0],[1347701442,0],[1347701443,0],[1347701444,0],[1347701445,0],[1347701446,0],[1347701447,0],[1347701448,0],[1347701449,0],[1347701450,0],[1347701451,0],[1347701452,0],[1347701453,0],[1347701454,0],[1347701455,0],[1347701456,0],[1347701457,0],[1347701458,0],[1347701459,0],[1347701460,0],[1347701461,0],[1347701462,0],[1347701463,0],[1347701464,0],[1347701465,0],[1347701466,0],[1347701467,0],[1347701468,0],[1347701469,0],[1347701470,0],[1347701471,0],[1347701472,"nan"]]);

hoop nullen. tegelijkertijd ontvang ik op de flukso.net site foutmeldingen bij de minuut weergave van de data. er gaat daadwerkelijk wel stroom door de diverse kabels voorzien van clamps. Aangezien ik geen data gevisualiseerd krijg, mijn vraag; zit de basis goed aangesloten? Waar of wat moet ik wijzigen zodat er data gaat stromen/visueel wordt gemaakt?
mvg

Jan

Hi,
did anyone manage to get the gas sensor working on a Schlumberger G4 RF1 meter? (see photos)
Thanks

It seems the lead attached to the water probe is not long enough to reach my Flukso, so I'd like to ask if there is a simple way of prolonging the lead? With simple I mean something a person can do without soldering as I don't have a soldering station at home or any skills in it :)

Thanks in advance.