Installation

Questions about installing and configuring a Fluksometer.

Initial configuration: NTP and firewall

by SergeDV on

Hi,

I have been configuring my Fluskometer to perform all network communications via the wired ethernet adapter. Nothing goes over the wireless ethernet adapter that I have disabled. As I am running my own DHCP and DNS server in my network, I have disabled dnsmasq in /etc/rc.d and put my DNS server's IP address in /etc/resolv.conf. In my setup the Fluksometer is behind a firewall that protects the device from access from the internet, so actually I could disable the firewall on the Fluksometer as well, but I have not done that (yet). What I was wondering is whether I have to open any ports on my firewall to make the Fluksometer sync with the Flukso web site. In the config of the Fluksometer firewall I can see that on the WAN side, the ports 5353 and 8080 are opened. What is the purpose of this? Also, I see that the Fluksometer is configured in the UTC time zone in /etc/config/system. This makes its clock of my Fluksometer not run correctly as I am not in that time zone. I cannot find the way to change it via the web interface. Can I just change it in /etc/config/system? Will it take into account the wintertime/summertime clock shift?

Kind regards

Flukso start niet meer op na het instellen van de parameters

by cece2406 on

De Flukso start niet meer op na het instellen van de parameters.
Ik stel de sensors in en wijzig het ip-adres van de lan.
Sla alles netjes op. Alles blijkt te werken totdat ik de FLS spanningsloos maak en terug laat opstarten. Geen heartbeat en geen lan led. Heb de fimware al een keer 4 opnieuw ingelezen en dit lukt perfect. Van het ogenblik ik parameters aanpas en terug opstart niks meer. Heeft iemand een oplossing voor dit probleem?

Frank

How come there is a delay in graphs displaying?

by LB on

Minute tab shows in real time, depending mostly on your Internet connection. The hour tab however can have up to five minutes delay and the day tab can be up to 30 min delayed. Why is this? And when does the month graph update after midnight?