I have been trying the FluksoMeter app for Iphone and it's pretty good. However the app gets stuck when IP address for the Flukso doesn't match. How do I set a fixed IP address for the Flukso in my own network, eg. 192.168.2.x?

The Fluksometer is very light so you don't need to drill holes and use screws for mounting. I fixed the FLM to a plastic conduit with UHU Patafix, a kneadable kind of putty which is easy to remove and relocate, leaves no traces and seems to hold forever. It even secures not too heavy picture frames to a wall. Nice stuff!

http://www.gysenbergs.info/data/fluksopatafix.jpg
http://www.gysenbergs.info/data/fluksomounted.jpg

Since today, I get this "Error - The call for sensor solar experienced a timeout. You are probably not in the same local network as the FLM.". The FLM is definitely in my network and it has worked before. In my opinion nothing has changed since last time. At this time, The solar sensor reports every second in the syslog. Any suggestion?

Hi everybody,

My new sensors just arrived and installed them. Then i went into the software to make port 4 and 5 active. ALso i've put in the correct name and constant so I have a beautifull chart in the end.

But now I've saved everything but I don't see my sensors in my account :(.
As a test I change the name of my current electricity clamp but no change name but he still works.

Anybody with good advice? I can't seem to fix this one.

Thanks in advance :)

I don't know what went wrong but i cannot reach the flukso at all it has a heartbeat but i don't know how it got one. In my DHCP table is it popping up with it's own ipadress but i cannot reach it. Could you please help me? already gone back to orginal firmware but no luck