I have 3 fases + N coming in, all these three have a 50 amp analog current clamp installed.

In the chart in dash I only see the first fase. I configured the sensors as 3 current clamp ports and tried number of fases setting 1 and enable all three sensors, hoping to see three charts. But I only see the first one (polarity of clamps is fine, )

Also I tried number of fases set to three, but then i cant enable port two and three, anyway i keep on seeing only the first attached clamp

- whats the correct setting to use ?
- is there any way to check the values directly like i can on dev/ttyS0 for my kamstrup ?

I tried fetching data from sensor 2 and 3 via http://192.168.0.131:8080/sensor/e799eef472075263e184cefc3b51d202?versio... But these array are empty ...

Please help me out

Hi Fluksonians, I have updated my Ipad 2 and my Ipad mini 1 to IOS 9 as of that moment the minute tab is not functioning anymore.
Is this a problem of the IOS 9 or Safari.
Any thoughts on this " problem" to get it working again.

is there an easy option to switch between wired and wireless connection to the flukso B?

rather than just being able to plug it in via ethernet to my router i have to plug it directly into my pc.
then set it up for wireless and unplug it hope it connects and works. and then setup for ethernet via the link below
surely there an easy way to be able to use it via ethernet or wifi?

this is all i can really find and its 5 years old

https://www.flukso.net/content/add-support-wired-ethernet-only-networks

Flukso 2B stopped around 09:00 /14 sept 2015
Reload, no resolution
Found that 247 was available, installed needed to boot a couple of times
local Mqtt tool showed 1 measurement gas/ electra of the smart meter
Loggedin locally in the flukso
-Sensors shows only 1 sensor analog that is not in use ( =chrome on android issue )
-New tabs kube and mqtt gives the login prompt ( magically fix the next morning around 8ish )

Log shows all is magically fixed around 8ish ( thanks whatever demon woke up to fix it )

Dash still don't show power produced by solar panels in the mrtg graph ...

i have bought a flukso and just added it to my dashboard and it shows

Resets Last heartbeat
2 02 Jul 2015 23:09:41

is this normal for a new unit or has it been used?

also shows version 245 is this the latest version?