Hi,

I have a very high powerconsumption I can't explain.
Therefore I want to monitor each seperate group individually to determine where this high powerconsumption is comming from.

I already use a Fluksometer device which monitors my total power consumption throug a P1 connector.

Can I use this device also to measure with clamps without breaking down my existing setup?

Any advice would help.

Thanks.

Paul

What means the variabele CONSTANT when I configure an analog sensor ?

Hello!

Gave my old Fluksometer some much needed attention and managed to get it going. Tried to upgrade it using the button in the menu but didn't work. Apparently my firmware version 215 is to old.
I'm using one of the older models (version 1 i think) of fluksometers. The webpage report FL02000086 as serial number.
Been browsing the site but can't find instructions on how to upgrade the firmware. No mention of it in the local web interface. What is the best method to upgrade to version 247?

thanks,

--- Mikael R

Hi,
Electricity reading continues fine but gas reading stopped exactly 1st January 2016.
Nothing has been changed in configuration....

Any idea?

Regards,
Paul

Hello,

I would be very happy if someone could help me. I am struggling to make my flukso working in "Ethernet mode". It has work fine in the past but I do not know why it does not work since a couple of months.

The only way I found to access my flukso is to :
- connect it to my pc using an Ethernet cable
- activate the "Wifi mode" (clicking on the Toggle mode during 4 seconds)
Then I succeed to connect to the interface in a browser using address 192.168.255.1

As soon as I toggle to the "Ethernet mode", only the leds 'power' and 'heart' are on, all the three other ones are off (globe, network and wifi).

Any suggestion, help is more than welcome!

Patrick