Hey Guys,

Just installed fluksometer yesterday and can see sensor and token id's but nothing else. When Im going to "Dash" there is nothing, when i click on "year" it says
Error - The call for sensor Consumption experienced a timeout. You are probably not in the same local network as the FLM.
Im sure the FLM is on the same subnet and talking to my router. If it wasnt then how does it gets the token and sensor id's out?
I know the IP it got from my router and I cannot web-browse to it but I can ping it. If I turn it off and plug my LAN cable it loses the wireless config. Is there something wrong with the device?

Also, I want to monitor "in-house" instead of going via external web, anyone got any ideas how to?

Regds

Debraj

Hello,

Is there any solution to measure electric consumption on a 3F without neutral ?

I had a owl device but couldn't get it right (the clamp didn't know in which direction the current was passing, to add the power or substract it to the measure).
Have you figured this out ?

Thanks in advance
Patrick

Hello!

Is anyone having interference problems with the wireless connection when the device is already instaled?

Thanks

My first startup of a Fluksometer FLM02B and I have stuffed it!

OK here's where I am at: plug in power to the meter. After a while it settles down to the following state:
heart+power lights ON for about 3 secs ... globe+heart+power lights ON briefly ... all lights OFF briefly .. & then repeats this cycle.

While in this state I used a paper clip to push in the toggle button for 2 minutes. (I feel a positive click of the button.) No change in lights during or after toggle button pressed. I disconnect power for 30 secs and reconnect. The above is repeated.

If I plug an Ethernet cable in (connected to PC) the cycle changes to: heart+power lights ON for about 3 secs ... power light on briefly ... & repeats.

Anyone help please !!!!

Hello,

Have heat pump 3 phase (400V / 3F + N).
In between I have purchased 3 x 50amp current-clamp and connected to Fluksometer v2.
Only the institution I have problems.
On sensor setting did number or phases = 3
Sensor 1 = enable
Name = Heat pump
Voltage = 230
Current = 50
Then I clicked save.
The other two sensor analog I entered nothing.
Are they setting good or should I set voltage 400V?
Measurement get by on just flukso
With no consumption or heat, I asked constant consumption of 90W at 230V setting and institution I have 160W 400V consumption.
Is that possible?

Best regards, Jeffry